Manufacturer
Reward Points	98
Location	BM2

Precision Flybar Control System includes:_ 1 CNC in-line flybar control arm system_ 1 CNC flybar seesaw system_ 2 CNC upper mixing arms._ 4 precision CNC linkage balls_ 8 precision miniature bearings pre-assembled_ all hardwaresASSEMBLY PRECAUTIONS1. Please make sure all the threaded screws are applied with enough loctite.2. The stock flybar is bigger than 1.98mm in outter diameter, therefore it may not go through the bearings across the seesaw. We supply two delrin pushings to replace two bearings so that the flybar rod can be slided through the seesaw. If one prefers to use bearings, the flybar rod can be sanded down slightly with sandpaper 300 to reduce the outter diameter down a little bit so it can be slided through the bearings.3. If ball linkages are tight, we recommend using 4.75mm ball sizers made by JR or HeliMax.4. If the flybar doesn't go through the bearings, sand the flybar end where the thread ends a little bit so it can go through the bearings and washers. 5. Washers supplied should be placed between the T-hub and the seesaw hub, not between the seesaw hub and the mixing arms. If placed between the mixing arms and the seesaw hub, it will cause binding because the clearance distance is not enough.

Customers who bought this product also bought the following products:

S4726

Kugellager für Mischerhebel Innovator

Scorpion 2215-18

Timing Belt 30

FUNCOPTER w/motor

Servo Retaining Plates