Homepage » Heli Spares-Electric » Mikado » Jazz 80-6-18

Jazz 80-6-18

Small Quantity avaliable (1-5pcs)

Expect a lot - a Jazz will fulfill it. Newest technological know-how shows you unknown features.

A BEC up to 18 cells was the attraction of the last year. A new high level electronic was create to developed to create a strong BEC without the well known interference problems. The excellent suppression of interference makes the optocoupler unneccessary

The Jazz ESCs have been optimized with new electronic circuits and our own EMV test bench to produce as low interference as never before. In comparison to usual ESCs for brushless motors it's about 10 times less. Especially in critical applications the better performance is obvious.

A real high light of the Jazz ESCs are their automatic commutation. The precommutation is selfadjusting in comparison to the actual motor and power data.

The Jazz ESCs are prepared to operate with new Lithium Ion / Polymer (LiPo Mode) batteries.

Due the 6 layer assembly of the PCB board with over all 1mm copper the Jazz ESCs keep "cool" even during long flights or in high power applications.

These are only a few features which set the Jazz off the market. Be sure a Jazz will convince you.

Kontronik Jazz 80-6-18 ESC handles a whopping 80 amps continuous (100 amp burst) and up to 25 volts input.

# Programmable modes: different default settings for different model types including glider, airplane, heli, car and boat, reversable rotation and competition.

# Ultra-low noise suppression circuitry for super-clean BEC power control to the Rx.

# Measures motor inductance and winding resistance and matches power accordingly.

# Adjustable soft-start timing.

# Custom "partial load capability" design allows for very high efficiency

(good!) when operating at less than full power (brushless systems are most inefficient when operated at less than full power, which can cause overheating and lower flight times).

# Adjustable frequency from 8kHz to ultra-high 32kHz for super smooth control and high effiency operation.

# EMF brake with 10 brake strength settings.

# Capable of much higher RPMs.

# Variable current limiting.

# Audible tones and LED for easy setup.

# Adjustable low voltage cutoff protection (0.8V default for NiCd and NiMH).

Data Sheet

New Kontronik Jazz 80-6-18 speed controller with BEC is for brushless motors and it is very powerful. It supports 6-18 Cells NiCd/NiMh, 2-6 cells Lipo.

New Kontronik Jazz 80-6-18 speed controller with BEC is for brushless motors and it is very powerful. It supports 6-18 Cells NiCd/NiMh, 2-6 cells Lipo.
Weight 34g without cables, 59g with carbles (carble cross section: 4/2.5mm)

Size: 52mm x 25mm x 11mm