This product was developed for you to make Advance plus controllers setting easier and to extend the possibilities of controller settings too.

Advance plus Prog-Card possibilities
• Brake on - brake is active
• Brake off - non active brake
• Timing low (soft timing) - for 2, 4, 6 pole motors. This timing gives maximum efficiency.
• Timing high (hard timing) - strongly recommended for outrunners
• Throttle curve linear - half throttle is equal to 60% of maximum RPM
• Throttle curve logarithm -half throttle is equal to 45% of power and 80% of maximum RPM
• ACCU NiXX - power pack type NiCd or NiMH
• ACCU Li-XX - power pack type Li-pol or Li-ion
• Cut off voltage high - cut off is set to 0,9 V per cell for NiCd/NiMH 3,0 V per cell for Li-xx
• Cut off voltage low - cut off is set to 0,7 V per cell for NiCd/NiMH 2,7 V per cell for Li-xx
• Cut off hard - motor is fully off immediately after reaching cut off voltage
• Cut off slow down - motor turns off slowly by power reduction.